 |
 |
 |
 |
KYNSHOT - Hydraulic Buffer for AR-15 with collapsible stock (3.25") - Light Model
This model is made lighter, a requires less force to cycle it than the standard AR-15 carbine KynSHOT Buffer. This is intended for soft cycling or under gassed guns that won't lock back on the last round with the standard carbine Hydraulic buffer or heavier buffers. For those shooters who want the benefits and smoothness of a hydraulic buffer but who have a gun that tends to cycle without as much force as your average AR-15. This buffer was developed specifically to meet the needs of .300 Blackout guns which tend to run on the softer side as compared to .223/5.56 guns. Also works for any .223/5.56 AR-15 carbine that runs on the softer side and may short stroke with the standard carbine model.
Reduce felt recoil, improve reliability, reduce bolt carrier speed, reduce wear on parts, reduce shock and vibration to optics, and suppress bolt bounce with this simple drop-in replacement. Designed for AR-15 rifles with a collapsible stock. This buffer has a piston that is hydraulically dampened to absorb the shock of impact from the bolt carrier's rearward motion and to prevent bolt bounce as a new cartridge is chambered. You will feel less recoil and smoother operation with this buffer and you will see less movement of your sights during recoil for faster shot to shot recovery time.
This buffer is made to the highest possible quality and durability standards. Can take all the punishment your rifle can dish out. Constructed using 17-4 Stainless Steel and is built to outlast your gun. The hydraulic seal and porting technology used in this buffer has been thoroughly proven which is why the warranty on this buffer is as impressive as it is. Designed for .300 BLK or any softer cycling AR-15. This could apply to a .223/5.56 gun with a gas system that just doesn't eject very hard which happens a small percentage of the time, or a .300 Blackout shooting subsonic loads which normally run very soft. .300 BLK guns running exclusively supersonic ammo may be fine with a standard hydraulic buffer model as long the bolt cycles firmly and ejects cases with authority.
For subsonic only .300 BLK guns a Sprinco reduced power (yellow spring) is recommended. For supersonic .300 BLK and .223/5.56 guns a Sprinco white or blue spring or a JP carbine buffer spring works very well.
Weight: 4.0 Ounces Length when Compressed: 3.25" Mil-Spec Hydraulic Fluids and Seals - Ambient operating temp certified for -30F - +150F
* DO NOT USE IN 9mm AR-15s. For 9mm AR15s use the Blitzkrieg Components 9mm buffer made by KynShot
Made in USA
ITAR Product - export of this
product is strictly prohibited without a valid export license issued by
the U.S. Department of State, in accordance with International Traffic
in Arms Regulations (ITAR). Purchase of this product is restricted to
U.S. Persons who do not intend to export this product or businesses with
a valid export license operating in compliance with all applicable ITAR
regulations.
Kynshot Hydraulic Recoil Buffers
|
|
 |
 |
 |
 |
|
 |


|