Gracoil Rifle Compression Butt Plate

Graco GraCoil Rifle Compression Plate

The Graco Rifle GraCoil is a compression butt plate for recoil reduction with an adjustable tension setting and adjustable pad plate, made to fit any shooters style. The Spring Tension of the Rifle system can be adjusted from 70 lbs. to 140 lbs. of recoil allowing the shooter to easily tune the Gracoil for optimal performance with his or her rifle and load. The spring tension levels on the rifle model are higher to accomodate magnum rifle recoil. The GraCoil has a maximum stroke of 5/16, producing a response time hardly detected, with no distractions between shots. This was determined to be the optimal compression length in order to get effective recoil control without causing too much movement in the gun or too much cheek sliding on the stock which could distract the shooter between shots. If you have been searching for a high quality product to reduce recoil, the GraCoil Rifle Compression Butt Plate is a great option. The pad plate can be adjusted up or down, side to side and for cant with plenty of adjustment to customize fit to the shooter for maximum comfort. Moving parts are stainless steel and slide on Teflon liners for a perfectly smooth, trouble free motion. The Gracoil mounting plates are aluminum. Requires little maintainance. Perfect for Large Caliber and Magnum Rifle shooters who need more recoil control than can be obtained through recoil pads alone. Also good for those who want to avoid the additional noise from a muzzle brake. Reduces shooter fatigue and discomfort and improves concentration. For rifles with recoil equal to or less than a .30-06, the standard shotgun model is preferred due to lower spring tension levels. For heavier recoiling rifles, the Graco GC15R rifle model should be used. The tuneability of this system allows it to be used with or without other accessories such as muzzle brakes.

This system adds 1 inch to overall stock length and length of pull. If same length of pull is desired, the stock must be cut to account for the length of this system. Aluminum mounting plates and pad plates come oversized so they can be ground down to match the customer's stock. A Grind-to-Fit recoil pad is then also ground down to match the pad plate. For wood stocks, three holes will need to be drilled in the back of the stock in order to mount the system. For synthetic stocks, a mounting plate will need to be fitted to the stock provide a strong mounting platform. Gunsmith installation is recommended.

* Grind-to-Fit Recoil Pads are not included and are available separately.

MADE IN USA